Instll A Ceiling Fan Wall Mount

For a flush mount fan thread the wires from the fan motor through the top housing trim ring if applicable and canopy.

Instll a ceiling fan wall mount.

Share it with us. The assembly slid onto the horizontally mounted shaft. Wiring will vary according the manufacturer. The distance between the hooks depends on the distance between the fan and the wall.

Make sure that the wire is not hanging too low between hooks. Attach the ceiling plate or bracket. For added electrical safety flip the breaker switch and turn off the main power supply. The ceiling plate or fan bracket is the fixture that your fan will be suspended from.

Turn the wall switch to the off position. Run the wires on one side of the pin in the downrod ball. Wall mounted or table fan. Add tip ask question comment download.

Install the ceiling hooks in a direct line toward the outlet you will be using. At the end of the day you ll want a ceiling fan that hangs down no lower than 7 feet and the edge of the blades are at minimum a few feet from the edges of the wall. Ceiling fan harbor breeze mayfield. This is for obvious safety as well as give it the best air flow.

First make sure your ceiling fan can be installed on angled ceilings. Step 7 install the canopy. If your ceiling is 12 feet or higher choose an 8 foot stepladder. Participated in the epilog contest 8.

Be the first to share did you make this project. Ladder use a ladder to reach the mounting bracket and hang the motor assembly as well as wire the ceiling fan. When you install a hook hang a link of chain on it to view your progress. Depending on the angle of the ceiling and your fan type you may also need an angled ceiling mount adapter.

Use the provided screws to tightly secure the ceiling plate in place. Hold the ceiling plate up to the fan box and pull all of the wires through the hole in its center. Use electrical tape to insulate all wire connections. Use the handle to mount on the wall with the two included wall brackets or simply use the sturdy handle for stabilizing on tables.

Remove the canopy by unfastening the external screws with a screwdriver. If your ceiling is 9 feet or higher choose a 5 foot stepladder. For a fan with a downrod thread the wires through the canopy trim ring if applicable canopy and downrod. Now i have a wall mounted fan that helps keep cool this tiny room i tend to spend some time in.

I wired the supply in the ceiling. Versatile in design the fan can either be used as a tabletop or wall mount fan.