Installing Garage Door Weather Strips

Pvc stop molding nails to the outside frame of the garage door.

Installing garage door weather strips.

Nails into the wood flange and position the weatherstripping so the entire length of the foam seals against the door. Tack the door weather stripping in place but don t drive the nails home yet. Hold each of the side pieces in place and nail them in the same fashion as you nailed the header piece. A miter saw will make fine cuts in your header piece and make your work easier.

How to install garage door weather stripping. When the door closes the flap on the stop molding presses against the door to provide a tight seal around the sides and top of the garage door. The stripping comes factory attached to a plastic piece that can be affixed directly to your existing garage door frame. Start at the top of the door and not at the sides.

You ll start by removing the old garage door weatherstripping then measuring cutting and installing the new pieces. Take out your nails and nail the header piece into position. Test the garage door to be sure it opens and closes smoothly. Use a hammer or a pry bar to pull out the nails.

Begin by carefully removing the existing weatherstripping. Screws are not included close the garage door. Trim the soft weather stripping at the top of the side pieces at about a 45 degree angle so the top and side pieces overlap nicely. Unplug the door opener.

Tips removing and installing new weather stripping for a door. Place all your tools outside the garage as you will install the weather stripping on the outside of the garage door. First rule for any garage door repair. Top and side garage door weatherstripping seals come in a variety of styles.

Next clamp the door in place either up or down depending on the task using vice grips one on each side of the door. Replace cracked and torn vinyl weatherstripping with this easy step by step guide. Take extra care to make sure that it doesn t damage the doorframe itself. Garage door top and side weather seal installation.

Using a miter saw cut square ends of the header piece. Top and side seals. Doorstop is made with built in weatherstripping specifically for garage doors. Handyman home repair tips replacing.

Make sure that the end of the top section weatherstripping is even with the end of the base. Put the door in manual operation by pulling the release.