Installing Garage Door Opener On Swing Out Door

Make entering and exiting your garage easier by installing an electric garage door opener.

Installing garage door opener on swing out door.

Attach brackets to the ceiling and door and position the end of the rail above the closed door. The exact location depends on the type of door. The garage door opener mounting bracket also called the header bracket secures the carriage tube to the wall above the door. The last step of making a swing out garage doors is installing the door opener.

Use the open ended adjustable wrench to loosen the bracket and remove the bracket on the door and the bracket above the door. Remove torque tube and slip on the drive motor. In this case you can just use the hinge to make the door swinging if you do not much time to install the rails. Otherwise using rails will give sturdier garage doors and excellent durability because the doors will be opened by following the trails only.

Place the opener on a ladder and use scrap lumber to get it at the height you need. This was installed on a door that was always a manual door. Unplug the existing garage door opener. Follow the manufacturer s instructions to assemble the opener and mount the rail to the header bracket above the door.

Install the battery or batteries in the new keypad following the manufacturer s directions. Lift the power unit. My 1st attempt at installing an electric garage door opener. Garage door opener installation is available starting at 127 including removal and haul away of old openers and other materials.

Visit ron hazelton s website for more home improvement projects. The opener is made by chamberlain b. To install a garage door opener first assemble the rail carriage pulley and motor compartment according to the instructions. Request service online in store or by phone and a licensed professional installer will contact you to schedule the installation date.

Align the opener s rail with the center of the garage door. Step by step garage door opener installation 1 this opener is designed to fit onto a torque tube spring system. Then program the keypad to the garage door opener. Pick out a four to six digit key code depending on.

Loosen the brackets securing it to the ceiling and gently lower it down. If the torque tube has already been installed remove it and slip the drive motor onto it. Refer to the manufacturer s directions for other types of springs.